"Change seal"
item 08.9 WATER INLET SEAL
Location Ref:
Exploded diagrams, Schematics and other documents
Click on an image to enlarge the exploded view
Installation
James
VIC
"Incorrect part was supplied. sent email to bg psrts but no reply received. still waiting for response."
Anthony
QLD
"Not as straight forward to change as you might think. basically half the machine needs to come apart gently to remove the pipe fitting to get at the seal. not overly difficult but definitely fiddly"
Anthony
VIC
"Water was leaking from around the bottom of the tank but it was actually the rubber seal that it connects into. had to remove the screws and the tope and back of the machine. then the housing around the seal. replaced the seal and put all back together. no more leaks"
Matthew
NSW
"Remove rear cover to fit new seal"
Noel
SA
"Remove water tank and back of machine. replace seal."
David
NSW
"Na"
Travis
WA
"Undo screws on unit but be sure to mark where they go back in. you will need a rather varied range of phillips drive screwdrivers though. because some of the screws are hard to get to"
Sharon
BRITISH COLUMBIA
"Remove all screws from back and top plate, remove screws from water inlet seal base. replace all screws"
Damien
ACT
"Take your time and remove as many screws as you can find. the better you can pop the entire unit apart the easier it is to visualise the seal location. i have seen guides that say to remove cable ties and tubes but this is not necessary if you just need to replace the seal. now gone from leaking water whenever the tank was installed to bone dry again"
